Video Selfviewdefault Fullscreenmode; Video Monitors; Video Osd Languageselection; Video Osd Encryptionindicator - Cisco TelePresence SX10 Quick Set Administrator's Manual

Cisco TelePresence SX10 Quick Set
Contents

Video SelfviewDefault FullscreenMode

Determine if the main video source (self-view) shall be shown in full screen or as a small
picture-in-picture (PiP) after a call. The setting only takes effect when self-view is switched on
(see the Video SelfviewDefault Mode setting).
Requires user role: ADMIN
Value space: <Off/Current/On>
Off: self-view will be shown as a PiP.
Current: The size of the self-view picture will be kept unchanged when leaving a call, i.e. if it
was a PiP during the call, it remains a PiP after the call; if it was fullscreen during the call, it
remains fullscreen after the call.
On: The self-view picture will be shown in fullscreen.
Video SelfviewDefault FullscreenMode: Current
Example:

Video SelfviewDefault PIPPosition

Determine the position on screen of the small self-view picture-in-picture (PiP) after a call. The
setting only takes effect when self-view is switched on (see the Video SelfviewDefault Mode
setting) and fullscreen view is switched off (see the Video SelfviewDefault FullscreenMode
setting).
Requires user role: ADMIN
Value space: <Current/UpperLeft/UpperCenter/UpperRight/CenterLeft/CenterRight/LowerLeft/
LowerRight >
Current: The position of the self-view PiP will be kept unchanged when leaving a call.
UpperLeft: The self-view PiP will appear in the upper left corner of the screen.
UpperCenter: The self-view PiP will appear in the upper center position.
UpperRight: The self-view PiP will appear in the upper right corner of the screen.
CenterLeft: The self-view PiP will appear in the center left position.
CentreRight: The self-view PiP will appear in the center right position.
LowerLeft: The self-view PiP will appear in the lower left corner of the screen.
LowerRight: The self-view PiP will appear in the lower right corner of the screen.
Video SelfviewDefault PIPPosition: Current
Example:
D15106.04 SX10 Quick Set Administrator Guide TC7.3, JULY 2015.
Introduction Web interface System settings System settings

Video Monitors

Set the monitor layout mode. Note that this video system supports only one monitor, so this
value is fixed and cannot be changed.
Requires user role: ADMIN
Value space: <Single>
Single: The layout is shown on the video system's monitor.
Video Monitors: Single
Example:

Video OSD LanguageSelection

This has been replaced with the UserInterface OSD LanguageSelection setting.

Video OSD EncryptionIndicator

This has been replaced with the UserInterface OSD EncryptionIndicator setting.
Video OSD Output
This has been replaced with the UserInterface OSD Output setting.

Video OSD LoginRequired

This setting is not applicable for this product. Removed from TC7.3.3.
www.cisco.com — Copyright © 2015 Cisco Systems, Inc. All rights reserved.
103
Administrator Guide
Setting passwords Appendices