Controlling General Audio - Kenwood DNX5350BT Instruction Manual

Return to the Top page
Controlling Audio
DSP select
You can select whether using DSP (Digital
Signal Processor) System.
1
Touch [Bypass] or [Through] of [DSP
Select] in the Audio SETUP screen.
Bypass
There is no effect by DSP.
Through
There is an effect by DSP.
NOTE
• When the mode is set to [Bypass], DSP System
cannot be adjusted.
98 98

Controlling General Audio

1
Touch [Audio Control].
2
Set each item as follows.
Fader #/Balance #
Adjust the volume balance around the
touched area.
[2] and [3] adjust the right and left volume
balance.
[5] and [∞] adjust the front and rear volume
balance.
Volume Offset*
Finely adjust the volume of the current source
to minimize the difference in volume between
different sources.
Subwoofer Level
Adjusts the subwoofer volume. This setting is
not available when subwoofer is set to "None".
Speaker setup (P.95).
See
Bass Boost
Sets the amount of bass boost among "OFF"/
"Level1"/ "Level2"/ "Level3".
* If you have increased the volume first, then
reduced the volume using the "Volume
Offset", the sound generated if you
suddenly switch to another source may be
extremely loud.