PMC Carrier Board Installation
1
PMC Carrier Board Installation
!
Caution
!
Warning
!
Caution
1-40
PCI mezzanine card (PMC) carrier boards mount above the
RAM200 mezzanine and (if installed) PMC module on the
MVME2603/2604 base board. To install a PMC carrier board for
additional PCI expansion, refer to
follows:
1. Attach an ESD strap to your wrist. Attach the other end of the
ESD strap to the chassis as a ground. The ESD strap must be
secured to your wrist and to ground throughout the
procedure.
2. Perform an operating system shutdown. Turn the AC or DC
power off and remove the AC cord or DC power lines from
the system. Remove chassis or system cover(s) as necessary
for access to the VMEmodules.
Inserting or removing modules with power applied
may result in damage to module components.
Dangerous voltages, capable of causing death, are
present in this equipment. Use extreme caution when
handling, testing, and adjusting.
3. Carefully remove the MVME2603/2604 from its VMEbus
card slot and lay it flat, with connectors P1 and P2 facing you.
Avoid touching areas of integrated circuitry; static
discharge can damage these circuits.
4. If PMC modules are to be installed on the carrier board,
install the modules at this point.
Figure 1-20
and proceed as