Bypass Feed Copying; Interruption Copying - Toshiba e-STUDIO520 Service Manual

4.2.4

Bypass feed copying

1) A sheet of paper is inserted into the bypass tray.
o The bypass feed sensor (S27) is turned ON. o "Set media type" appears.
o Select the media type and paper size. o "Ready for bypass feeding" appears.
2) Pressing the [START] button
o "Ready for bypass feeding" changes to "COPYING".
o The drum, developer unit, transfer belt and fuser roller rotate.
o The main charger, developer bias and discharge LED (ERS) are turned ON. Each fan rotates at a
high speed.
3) Bypass feeding
o The bypass pickup solenoid (SOL3) is turned ON. The feed motor (M20) is turned ON.
- The bypass pickup roller is lowered.
o The bypass feed clutch (CLT4) is turned ON.
- The bypass pickup roller and bypass feed roller start to rotate.
o Aligning operation
- The paper reaches the registration roller.
- After a certain period of time, the bypass pickup solenoid (SOL3) and bypass feed clutch (CLT4)
are turned OFF.
4) Hereafter, the operation 3) to 6) of "4.2.3 Drawer feed copying with [START] button" is repeated.
4.2.5

Interruption copying

1) Pressing the [INTERRUPT] button
o The LED "INTERRUPT" is turned ON.
o The copying operation in progress stops temporarily. Carriage-1 and -2 return to their appropriate
positions.
o "Job interrupted job 1 saved" appears.
o The automatic density and reproduction ratio 100% are set. (The set number remains the same.)
2) Selecting the desired copy conditions
3) After interruption copying is finished:
o When the LED "INTERRUPT" is turned OFF by pressing the [INTERRUPT] button, the equip-
ment returns to the status before the interruption.
o "Ready to resume job 1" appears.
4) Pressing the [START] button
o The copying operation before the interruption resumes.
March 2005 © TOSHIBA TEC e-STUDIO520/600/720/850 GENERAL OPERATION
4 - 7
4