Makita BTP130 Instruction Manual page 6

Selecting the action mode
This tool employs an action mode changing lever. Select
one of the four modes suitable for your work needs by
using this lever.
For rotation with impact, turn the lever so that the arrow
on the lever points toward the
1
007158
For rotation with hammering, turn the lever so that the
arrow points toward the
007159
For rotation with clutch, turn the lever so that the arrow
points toward the mark on the tool body.
007160
For rotation only, turn the lever so that the arrow on the
lever points toward the
tool body.
1
007161
Sliding to the mark is high rotation and the
is low rotation.
mark on the tool body.
1. Action mode
changing lever
mark on the tool body.
1. Action mode
changing lever
1
1. Action mode
changing lever
1
mark or the mark on the
1. Action mode
changing lever
1
007162
Before operation, always make sure that the lever is
correctly set to your desired mode mark and use the tool
at an appropriate speed for your work.
CAUTION:
When using the action mode change lever, use only
•
when the tool stops. But when the lever does not
easily move, pull the switch trigger slightly to rotate
the spindle and then move the lever.
Always set the lever correctly to your desired mode
•
mark. If you operate the tool with the lever
positioned halfway between the mode marks, the
tool may be damaged.
Adjusting the fastening torque (Only for
screwdriving operation mode "
3
007163
The fastening torque can be adjusted in 16 steps by
turning the adjusting ring so that its graduations are
aligned with the pointer on the tool body. The fastening
torque is minimum when the number 1 is aligned with the
pointer, and maximum when the number 16 is aligned
with the pointer.
The clutch will slip at various torque levels when set at
the number 1 to 16.
Before actual operation, drive a trial screw into your
material or a piece of duplicate material to determine
which torque level is required for a particular application.
NOTE:
In modes other than screwdriving mode, the
•
adjusting ring can be placed at any position
because it does not work.
mark
6
1. Action mode
changing lever
")
1. Adjusting ring
2. Graduation
1
3. Pointer
2