Honeywell L5200 Series Installation And Setup Manual page 33

Program the Communications Module (Continued)
GSM Fault Time (min)
00
GSM Rollover
No
GSM 24 Hour Test
No
19. Select "GSM Fault Time (min)". Enter the time delay (in minutes) on the keypad.
Options
00-99
20. If "WiFi and GSM" was selected in step 2, two additional programming fields are
displayed. Select "GSM Rollover", the system toggles between "Yes" and "No".
19. Select "GSM 24 Hour Test", the system toggles between "Yes" and "No".
20. If "GSM" was selected in step 2, select "Save" and then select "OK" when the
"Programming Done" screen appears. Proceed to "Diagnostics" section in order to
register the device.
- 33 -
LYNX Touch Installation and Setup Guide
Programming the Control