Assembly Step - Horizon Fitness Elite T3000 Owner's Manual

ASSEMBLY STEP 1-1

(T3000 ONLY)
T3000
BOLT (A)
ONLY M8x20 mm
Qty: 6
RIGHT CONSOLE MAST
LEFT CONSOLE MAST
BOLTS (A)
SPRING WASHERS (B)
ARC WASHERS (C)
MAIN FRAME BRACKET
6
(T3000)
HARDWARE foR STEP 1-1 :
SPRING WASHER (B) ARC WASHER (C) SCREW (D)
Φ8.2xΦ17 mm Φ4x20 mm
8.2 mm
Qty: 6 Qty: 6 Qty: 4
* This step is for T3000 models only.
A Cut the yellow banding straps and lift the running
deck upward to remove all contents from underneath
the running deck.
B Open hardware for step 1.
LEAD WIRE
Slide main frame boot up console mast.
C
CONSOLE CABLE Pull lead wire through right console mast.
After pulling the lead wire through the mast, the
top of the console cable should be located at
the top of the mast. Detach and discard lead wire.
NOTE: Do not pinch console cable when placing
the mast onto the main frame bracket.
Place right console mast over main frame
D
bracket.
E Attach console mast to main frame
bracket using 3 bolts (a), 3 spring
washers (b) and 3 arc washers (c).
ASSEMBLY STEP 1-1
(T3000 ONLY)
MAIN FRAM BOOT
SCREW (D)
(T3000)
F Slide main frame boot down over main frame
bracket.
g Repeat steps D–F on other side.
H Attach main frame boots to main frame using 4
screws (d).
T3000
ONLY
7