Ups Settings - Buffalo TeraStation User Manual

UPS Settings

An UPS (Uninterruptible Power Supply) can protect the TeraStation from power outages and brownouts. To use the
TeraStation with a UPS, proceed as follows:
1
Plug the power cable of the UPS to a wall socket.
2
Connect the AC cable of the TeraStation to the UPS.
3
Connect the UPS to the TeraStation with a USB or serial connection.
Note:
When using the USB cable, connect to the USB port on the rear. When using the dedicated cable, connect to the
dedicated UPS port on the rear.
4
Turn on the UPS, then the TeraStation.
5
In the Web Admin interface, click [System] - [Power Management] - [UPS Settings].
6
Click [Modify Settings].
7
Notes:
• If the UPS has shut down the TeraStation because of a power outage, make sure that power has been restored before
restarting the TeraStation. If the TeraStation is restarted after a shutdown, but power is not available, then the UPS
will not shut down the TeraStation a second time even if its battery is running low.
• If UPS recovery is enabled, the TeraStation will automatically restart when normal power is restored.
1 Configure the desired settings.
If your TeraStation is connected directly to the UPS, select [synchronize
with UPS connected to this TeraStation]. To have the UPS shut down
multiple TeraStations on the same network, select [synchronize with
UPS connected to other TeraStation on the network] and enter the IP
address of the TeraStation that is connected directly to the UPS in the
field below.
2 Click [Save].
3 Reboot your TeraStation.
The settings are applied after the TeraStation is restarted.
36