Removing The Generator - Yamaha XP500 2001 Service Manual

STARTER CLUTCH AND GENERATOR
5-30

REMOVING THE GENERATOR

1. Remove:
S generator rotor cover
NOTE:
Loosen each bolt 1/4 of a turn at a time, in
stages and in a crisscross pattern.
After all of the bolts are fully loosend, remove
them.
2. Remove:
S generator rotor nut 1
S spacer 2
NOTE:
S While holding the generator rotor 3 with the
sheave holder 4 , loosen the generator rotor
nut.
S Do not allow the sheave holder to touch the
projection on the generator rotor.
Sheave holder
90890-01701
3. Remove:
S generator rotor 1
(with the flywheel puller set 2 )
S woodruff key
NOTE:
S Remove the rotor 1 using the flywheel puller.
S Center the flywheel puller over the rotor.
Make sure after installing the holding bolts that
the clearance between the flywheel puller and
the rotor is the same everywhere. If necessary,
one holding bolt maybe turned out slightly to
adjust the flywheel puuler's position.
CAUTION:
Cover the crankshaft end with the box
wrench for protection.
Flywheel puller set
90890-01362
ENG