Permanent Installation - Honeywell 2202 User Manual

PERMANENT INSTALLATION

SECURING YOUR SAFE TO THE FLOOR
This safe includes a special knockout insert located on the bottom which
allows permanent and secure installation to the floor. Mounting hardware is not
included and depending on the type floor (Concrete or wood) it should be
purchased separately from your local retailer.
1. Open the safe and remove all the
contents (including any shelves if
included with safe) and locate the cap in
the center of the safe floor. Using pliers,
remove the cap by turning counter
clockwise (left).
2. To remove the plug you must carefully
lay the safe down on the back and
remove it by pushing it out with a
screwdriver. Once the plug is removed,
return the safe to the upright position.
3. Position the safe in the area where you
want to secure it and using a marking
pen, mark the exact location of the
mounting hole.
WOOD - If installing on a wood floor, a lag
screw and large washer should be used to
secure the safe to the floor.
CONCRETE - If installing on a concrete
slab, a concrete insert, screw and large
washer should be used.
1.
2.
3.
6