Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for HIKVISION DS-2CC502PN-IR1
Summary of Contents for HIKVISION DS-2CC502PN-IR1
- Page 1 IR Dome Camera· User Manual IR Dome Camera User Manual UD.6L0201D0065A01...
- Page 2 IR Dome Camera· User Manual Thank you for purchasing our product. If there are any questions, or requests, please do not hesitate to contact the dealer. This manual applies to following cameras: Models Models DS-2CC502P(N)-IR1(IR3) DS-2CC512P(N)-IR1(IR3) DS-2CC592P(N)-IR1(IR3) DS-2CC5182P(N)-IR1(IR3) DS-2CC5192P(N)-IR1(IR3) DS-2CC51A2P(N)-IR1(IR3) DS-2CC5172P(N)-IR1T DS-2CC5182P(N)-IR1T (IR3T)
- Page 3 IR Dome Camera· User Manual security or signaling aspects of this product. UL MAKES NO REPRESENTATIONS, WARRANTIES OR CERTIFICATIONS WHATSOEVER REGARDING THE PERFORMANCE OR RELIABILITY OF ANY SECURITY OR SIGNALING RELATED FUNCTIONS OF THIS PRODUCT.” 0100001021012...
-
Page 4: Regulatory Information
IR Dome Camera· User Manual Regulatory Information FCC Information FCC compliance: This equipment has been tested and found to comply with the limits for a digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. - Page 5 IR Dome Camera· User Manual 2002/96/EC (WEEE directive): Products marked with this symbol cannot be disposed of as unsorted municipal waste in the European Union. For proper recycling, return this product to your local supplier upon the purchase of equivalent new equipment, or dispose of it at designated collection points.
-
Page 6: Safety Warnings And Cautions
IR Dome Camera· User Manual Safety Warnings and Cautions Please pay attention to the following warnings and cautions: Hazardous Voltage may be present: Special measures and precautions must be taken when using this device. Some potentials (voltages) on the device may present a hazard to the user. This device should only be used by Employees from our company with knowledge and training in working with these types of devices that contain live circuits. - Page 7 IR Dome Camera· User Manual attached is also connected to properly wired grounded receptacles and are approved medical devices. Power Connect and Disconnect: The AC power supply cord is the main disconnect device to mains (AC power).The socket outlet shall be installed near the equipment and shall be readily accessible.
- Page 8 IR Dome Camera· User Manual Perchlorate Material: Special handling may apply. See www.dtsc.ca.gov/hazardouswaste/perchlorate. This notice is required by California Code of Regulations, Title 22, Division 4.5, Chapter 33: Best Management Practices for Perchlorate Materials. This device includes a battery which contains perchlorate material. Taiwan battery recycling: Please recycle batteries.
- Page 9 IR Dome Camera· User Manual Lead Content: Please recycle this device in a responsible manner. Refer to local env ironmental regulations for proper recycling; do not dispose of device in unsorted municipal waste.
-
Page 10: Safety Instruction
IR Dome Camera· User Manual Safety Instruction These instructions are intended to ensure that user can use the product correctly to avoid danger or property loss. The precaution measure is divided into “Warnings” and “Cautions” Warnings: Serious injury or death may occur if any of the warnings are neglected. - Page 11 IR Dome Camera· User Manual responsibility for problems caused by unauthorized repair or maintenance.) To reduce the risk of fire or electrical shock, do not expose this product to rain or moisture. This installation should be made by a qualified service person ...
- Page 12 IR Dome Camera· User Manual The sensor may be burned out by a laser beam, so when any laser equipment is being used, make sure that the surface of the sensor will not be exposed to the laser beam. Do not place the camera in extremely hot or cold temperatures ...
-
Page 13: Table Of Contents
IR Dome Camera· User Manual Table of Contents 1 Introduction ..............13 1.1 Product Features ............ 13 1.2 Overview ............... 14 2 Installation................16 2.1 Installation of Camera A ......... 16 2.2 Installation of Camera B ......... 21 2.3 Wiring ..............24 Appendix................26 1 Glossary .............. -
Page 14: Introduction
IR Dome Camera· User Manual 1 Introduction 1.1 Product Features This camera adopts high performance sensor and advanced print circuit board design techno logy. It possesses of high resolution, low distortion, and low noise features, etc. It is extremely suitable for surveillance system and image process system. -
Page 15: Overview
IR Dome Camera· User Manual Advanced engineering design, High Reliability Ingress Protection: IP66 1.2 Overview The appearances of the cameras are shown in Figure 1-1 and Figure 1-2. Camera A: Figure 1-1 Overview of DS-2CC502/512/592/5182/5192/51A2P(N)-IR1(IR3) and 5172/5182P(N)-IR1T(IR3T) 1 Power Supply Interface 2 Video Interface 3 Mounting Base 4 Liner... - Page 16 IR Dome Camera· User Manual Figure 1-2 Overview of DS-2CC502/512/592/5132P(N)-IR 1 Mounting Base 2 Screw 3 Enclosure 4 Sphere...
-
Page 17: Installation
IR Dome Camera· User Manual 2 Installation Before you start: Please make sure that the device in the package is in good condition and all the assembly parts are included. IR dome camera is usually used for outdoor or indoor ... - Page 18 IR Dome Camera· User Manual Loosen the set screw to separate the enclosure and the dome. Trim Ring Enclosure Dome Set Screw Mounting Base Figure 2-1 Disassemble the Dome 2. Attach the drill template to the ceiling and drill the mounting holes in the ceiling according to the template.
- Page 19 IR Dome Camera· User Manual Figure 2-2 Drill Template 3. Attach the mounting base to the ceiling and align the holes with the mounting holes. Fix it to the ceiling with the set screws.
- Page 20 IR Dome Camera· User Manual Figure 2-3 Fix the Mounting Base 4. Route the cables and connect the power supply and output the video on a monitor. 5. Install the dome to the mounting base and then install the enclosure w ith the set screw as shown in Figure 2-4. Mounting Base Dome Enclosure...
- Page 21 IR Dome Camera· User Manual 6. Adjust the view angle. Loosen the screw on the dome. According to the image on the monitor, adjust the dome to get the desired view angle. Tighten the screw. Note: The adjustable tilt angle range is from 0° to 75° . Figure 2-5 Adjust the View Angle 7.
-
Page 22: Installation Of Camera B
IR Dome Camera· User Manual Trim Ring Figure 2-6 Finish Installation 2.2 Installation of Camera B Note: The models of camera B are DS-2CC502/512/592/5132P(N)-IR. Steps: 1. Loosen the set screw to separate the enclosure and the dome. 2. Attach the drill template to the ceiling and drill the mounting holes in the ceiling according to the template. - Page 23 IR Dome Camera· User Manual Figure 2-7 Drill Template 3. Attach the mounting base to the ceiling and align the holes with the mounting holes. Fix it to the ceiling with the set screws.
- Page 24 IR Dome Camera· User Manual Mounting Base Dome Enclosure Figure 2-8 Fix the Mounting Base 4. Route the cables and connect the power supply and output the video on a monitor. 5. Install the dome to the mounting base and then install the enclosure Figure 2-8.
-
Page 25: Wiring
IR Dome Camera· User Manual Figure 2-9 Tighten the Screw 2.3 Wiring Please make sure that the power adapter can match with that of the camera. The standard power supply of the camera is 12V DC (Please refer to technical specifications for more details). Please plug the power adapter not too far away because the ... - Page 26 IR Dome Camera· User Manual Figure 2-10 Connections...
-
Page 27: Appendix
IR Dome Camera· User Manual Appendix 1 Glossary Note: The glossary gives brief explanations to the basic operation principle or the basic function of the camera. However, it doesn’t mean the listed functions are all supported by these series of cameras. -
Page 28: White Balance
IR Dome Camera· User Manual signal remains essentially. When under low illumination, AGC will regulate the gain and amplification of the video signal. S/N ratio: It is the ratio of Signal voltage to noise voltage. The ratio is larger, the effect of noise is less, and the image is clearer. White Balance: White balance can remove the unrealistic color casts. - Page 29 IR Dome Camera· User Manual This function allows you to block or mask certain area of a scene, thus prevent the personal privacy from recording or live view ing. OSD (On Screen Display): OSD is the texts superimposed on a screen. It can show the menu on the screen.
-
Page 30: Digital Zoom
IR Dome Camera· User Manual HLC (High Light Compensation): The HLC is capable of detecting and reversing the bright spots in the picture (such as headlights) to black so as to achieve optimum picture quality. Digital Zoom: Digital zoom helps to crop the entire image, and then digitally enlarge the size of a portion of image that is needed to zoom in on. -
Page 31: Troubleshooting
IR Dome Camera· User Manual 2 Troubleshooting Problem 1: Why does the camera restart intermittently? And the problem is much more serious when infrared lights of IR camera are turned on at night. Possible Reasons: The main and common reason is power supply shortage. This problem may happen to the IR camera especially at night, because the infrared lights are turned on at night and increase the power consumption. - Page 32 IR Dome Camera· User Manual Problem 3: The camera is installed w ith an auto-iris lens. You adjust the focus to get a clear image in the daytime. But the image is defocused at night. Possible Reasons: In the daytime, the illumination is high, so the iris is adjusted to a small size automatically.
-
Page 33: Technical Maintenances
IR Dome Camera· User Manual Or the iris driven mode of the camera does not match with the mode of auto-iris lens. To Solve the Problem: Check the auto-iris lens connector to ensure good contact. Set the iris driven mode of the camera the same as that of lens. The modes can be VD (video drive) or DD (direct drive). - Page 34 IR Dome Camera· User Manual The bubble is of transparent plastic. The dust, oil a nd finger print, etc. will cause scratch or image blur. Please refer to the fo llowing method to clean the bubble. Handling dust Use oil free soft brush or blowing dust ball to clean the dust. Handling o il ...
- Page 35 IR Dome Camera· User Manual...