ENGLISH (Original instructions) SPECIFICATIONS Model GA4034 GA4534 GA5034 Depressed center wheel diameter 100 mm 115 mm 125 mm Max. wheel thickness 6.4 mm 6.4 mm 6.4 mm Spindle thread Rated speed (n)/No load speed (n 11,000 min 11,000 min 11,000 min...
Do not abuse the cord. Never use the cord for 19. Do not use the power tool if the switch does carrying, pulling or unplugging the power tool. not turn it on and off. Any power tool that Keep cord away from heat, oil, sharp edges or cannot be controlled with the switch is dangerous moving parts.
Page 4
Do not use accessories which are not exposed metal parts of the power tool "live" and specifically designed and recommended by could give the operator an electric shock. the tool manufacturer. Just because the Position the cord clear of the spinning accessory can be attached to your power tool, it accessory.
Page 5
d) Use special care when working corners, c) When wheel is binding or when interrupting a sharp edges etc. Avoid bouncing and snagging cut for any reason, switch off the power tool the accessory. Corners, sharp edges or bouncing and hold the power tool motionless until the have a tendency to snag the rotating accessory wheel comes to a complete stop.
21. Before using the tool on an actual workpiece, FUNCTIONAL DESCRIPTION let it run for a while. Watch for vibration or wobbling that could indicate poor installation or a poorly balanced wheel. CAUTION: 22. Use the specified surface of the wheel to Always be sure that the tool is switched off and •...
Page 7
Mount the wheel guard with the protrusion on the wheel ASSEMBLY guard band aligned with the notch on the bearing box. Then rotate the wheel guard to such an angle that it can protect the operator according to work. Be sure to CAUTION: tighten the screw securely.
CAUTION: 1. Lock nut After operation, always switch off the tool and wait • 2. Depressed until the wheel has come to a complete stop center grinding before putting the tool down. wheel/Multi-disc 3. Inner flange Grinding and sanding operation ALWAYS hold the tool firmly with one hand on housing and the other on the side handle.
Page 9
Operation with abrasive cut-off / diamond wheel (optional accessory) 1. Lock nut 2. Abrasive cut-off wheel/diamond wheel 3. Inner flange 4. Wheel guard for abrasive cut-off wheel/diamond wheel 010799 The direction for mounting the lock nut and the inner flange varies by wheel thickness. Refer to the table below.
If you need any assistance for more details regarding the loading and susceptibility to twisting or binding these accessories, ask your local Makita Service Center. of the wheel in the cut and the possibility of Wheel guard (Wheel cover) For depressed center kickback, wheel breakage and overheating of the •...