Draytek Vigor2860 Series User Manual page 122

When you finish the configuration, please click OK to save and exit this page.
D e t a i l s
D e t a i l s
There are two configuration pages for LAN1, Ethernet TCP/IP and DHCP Setup (based on
IPv4) and IPv6 Setup. Click the tab for each type and refer to the following explanations for
detailed information. Below shows the settings page for IPv6.
It provides 2 daemons for LAN side IPv6 address configuration. One is RADVD(stateless)
and the other is DHCPv6 Server (Stateful).
Available settings are explained as follows:
Item
RADVD Configuration
Vigor2860 Series User's Guide
external DNS server by establishing a WAN (e.g.
DSL/Cable) connection.
P a g e f o r L A N 1 – I
P a g e f o r L A N 1 – I
Description
Enable – Click it to enable RADVD server. The router
advertisement daemon (radvd) sends Router Advertisement
messages, specified by RFC 2461, to a local Ethernet LAN
periodically and when requested by a node sending a Router
Solicitation message. These messages are required for IPv6
stateless auto-configuration.
Disable – Click it to disable RADVD server.
P v 6 S e t u p
P v 6 S e t u p
112