Mounting Conn Card - NEC NEAX 2000 IPS System Manual
Internet protocol server ccis system manual
Hide thumbs
Also See for NEAX 2000 IPS:
- Command manual (1038 pages) ,
- Installation manual (619 pages) ,
- Reference manual (421 pages)
Table of Contents
Advertisement
Mounting CONN Card
When providing the CONN (PZ-M542/PZ-M557) card to connect a coaxial cable for
30DTI card, do the following installation.
(1)
Confirm the correct switch settings of the CONN card.
See CHAPTER 4.
(2)
Connect the CONN card to LTC connector on BWB in the PIM which accommodates DTI/CCT
cards as shown below.
STEP1: When using LTC0 or LTC2 connector to mount the PZ-M542/PZ-M557 card, take off the
PLATE from the PZ-M542/PZ-M557 card. Then, overturn the PLATE and secure it to the card
with screws.
When using LTC1 or LTC3 connector to mount the PZ-M542/PZ-M557 card, skip STEP1
NOTE:
The PLATE and screws are attached to the PZ-M542/PZ-M557 card.
Page
407,
Page 409
Connection of PZ-M542/PZ-M557 and PLATE
PLATE
PZ-M542/PZ-M557
SCREW
INSTALLATION PROCEDURE FOR DIGITAL CCIS
– 70 –
CHAPTER 2 INSTALLATION
ATTENTION
Contents
Static Sensitive
Handling
Precautions Required
NWA-008853-001 Rev.3.0
97ch2001.fm
Advertisement
Table of Contents
