Honda 1992 Accord Coupe Owner's Manual page 115

Cooling System (cont'd)
1. Set the heater temperature control dial/lever to maximum heat.
2. Remove the radiator cap and loosen the drain plug when the
radiator is cool, and drain the radiator.
RADIATOR CAP
DRAIN PLUG
3. Remove the drain bolt from the
rear side of the cylinder block,
and drain the engine and heater.
4.Apply non-hardening sealant to
the drain bolt threads, then rein-
stall the bolt and tighten it se-
curely.
5. Tighten the radiator drain plug se-
curely.
6. Mix the recommended antifreeze
with an equal amount of low-
mineral or distilled water and fill
the reservoir to maximum, as
illustrated.
7. Loosen the air bleed bolt in the
water outlet, then fill the radiator
to the filler neck with the coolant
mixture. Tighten the bleed bolt as
soon as coolant starts to run out
in a steady stream without bub-
bles.
8. With the radiator cap off, start the engine and let it run until
warmed up (fan goes on at least twice). Then, if necessary, add
more coolant mix to bring the level back up to the filler neck.
9. Put the radiator cap on, then run the engine again and check for
leaks.
DRAIN BOLT
FILLER NECK
Fill to here.
BLEED
BOLT
Fill to here.