Honda tourer Owner's Manual page 219

06/09/21 10:22:15 32SED640_219
Audio System (A Type)
SCAN The SCAN function
samples all the stations with strong
signals on the selected band. To
activate it, press the SCAN button,
then release it. You will see SCAN in
the display. The system will scan up
the band for a station with a strong
signal. When it finds one, it will stop
and play that station for
approximately five seconds. If you do
nothing, the system will then scan
for the next strong station and play
that for five seconds. When it plays a
station that you want to continue
listening to, press the SCAN button
again.
216
Comfort and Convenience Features
Preset You can store the
frequencies of your favourite radio
stations in the three preset bars.
Each side of the bars (1 6) will
store one frequency on each AM
band (LW, MW), and two
frequencies on the FM band.
To store a frequency:
1. Select the desired band, AM (LW),
AM(MW) or FM. FM1 and FM2
let you store two frequencies with
each preset bar.
2. Use the TUNE, SEEK, or SCAN
function to tune the radio to a
desired station.
3. Pick the preset number (1
you want for that station. Press
the left or right side of the bar and
hold it until you hear a beep.
4. Repeat steps 1 to 3 to store a total
of six stations on each AM (LW,
MW) and twelve on FM.
Once a station's frequency is stored,
simply press and release the left or
right side of the proper preset bar to
tune to it.
The preset frequencies will be lost if
your vehicle's battery goes dead, is
disconnected, or the radio fuse is
removed.
6)