Makita LS1017L Technical Information page 29

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3] -9. Support arm (cont.)
ASSEMBLING
(3) Set Friction ring and insert Support arm to Locking rod. And insert Clamp plate and two Flat washer 10, and then temporarily
tighten M10 Locknut.
Clamp plate
Big inner diameter side
Clamp plate should be set with
the big inner diameter side to
Support arm side.
(4) Temporarily attach Bevel pointer with M4x12 Cross
head screw.
Working table
Bevel pointer
Fig. 92
(6) Set Sliding bar rear cover by tapping it with a plastic hammer.
Sliding bar rear cover
Fig. 94
Friction ring
When assembling, be sure to clean Friction ring and around it.
And apply Makita grease N No.1 a little on Friction ring.
Support arm
M4x12 Cross head screw
Plastic hammer
Support arm
Flat washer 10
M10 Locknut
Clamp plate
Locking rod
Fig. 91
(5) Insert Sliding bar into Support arm.
Before inserting Sliding bar, apply grease
to Linear bearing (inside Support arm) to
make Sliding bar moves smoothly.
(7) Fasten Sliding bar rear cover with two M5x15 Cross
head screws and two M5x12 Cross head screws.
M5x15 Cross head screw
Adjustment of the tightening
force of Locknut will be done
after attaching Up blade guard.
Support arm
Sliding bar
Fig. 93
Sliding bar rear cover
M5x12 Cross head screw
Fig. 95
P 26/ 45