Sip Configuration Menu (Sip Phones Only); Sip General Configuration Menu - Cisco 7931G Administration Manual

Chapter 4 Configuring Settings on the Cisco Unified IP Phone
Table 4-7
Designation
(Authentication
icon)
(Encryption icon)

SIP Configuration Menu (SIP Phones Only)

The SIP Configuration menu is available on SIP phones. This menu contains these sub-menus:
•
•

SIP General Configuration Menu

The SIP General Configuration menu displays information about the configurable SIP parameters on a
SIP phone.
Table 4-8 SIP General Configuration Menu Options
Option
Preferred CODEC
Out of Band DTMF
Register with Proxy
Register Expires
Cisco Unified IP Phone 7931G Administration Guide for Cisco Unified Communications Manager 8.0 (SCCP and SIP)
OL-20798-01
Cisco Unified Communications Manager Server
Designations (continued)
Description
Appears as a shield and indicates that the call is from a trusted device and that the
connection to the Cisco Unified Communications Manager is authenticated. For
more information about authentication, see the
Manager Security
Appears as a padlock and indicates that the call is from a trusted device and that
the connection to the Cisco Unified Communications Manager is authenticated
and encrypted.
The Encryption icon is also displayed when a Cisco Unified IP phone is
configured as protected. Protected calls are not authenticated.
For more information, see the
Guide.
SIP General Configuration Menu, page 4-19
Line Settings Menu (SIP Phones Only), page 4-21
Table 4-8 describes the options in this menu.
Description
Displays the CODEC to use when a call is
initiated. This value will always be set to none.
Displays the configuration of the out-of-band
signaling (for tone detection on the IP side of a
gateway). The Cisco Unified IP phone (SIP)
supports out-of-band signaling by using the
AVT tone method. This value will always be set
to avt.
This value will always be set to Yes.
Displays the amount of time, in seconds, after
which a registration request expires.
Guide.
Cisco Unified Communications Manager Security
To Change
Display only—cannot configure.
Display only—cannot configure.
Display only—cannot configure.
From Cisco Unified Communications Manager
Administration, choose Device >
Device Settings > SIP Profile.
Device Configuration Menu
Cisco Unified Communications
4-19