Advertisement
Once your eyewear is paired with your Bluetooth enabled device, it will normally `Link' or `Connect' each time it is turned on, so as to
send and receive voice communication and music to and from only that device. With some cell and smart phones, on occasion you may
have to go to the Bluetooth menu and instruct your phone to again `Pair' or 'Link', then 'Connect' to your eyewear.
To make a call, use your cell phone as normal. You do not have to press any button on your eyewear.
If your cell phone has voice-dial capability, press the 'Function' button once, then speak into your eyewear so your cell phones dials.
To answer a call, press the 'Function' button once and release. To hang up, press the 'Function' button once and release.
All music play functions are controlled by your cell/smartphone and music player. The volume controls on your eyewear may or may not
control the volume set on your cell/smartphone, or music player.
After you have your eyewear paired for the first time, you may turn it off at any time by pressing and holding the 'Function' button for 5-8
seconds, during which it will blink blue 3 times, then blink red 3 times, then turn itself off.
You may turn your eyewear on at any time, by pressing and holding the 'Function' button down for 3 seconds, until it flashes blue every
second or two.
YOUR EYEWEAR'S POWER SYSTEM:
You eyewear, when fully charged, provides about 6 hours of continuous voice communication and about 8 hours of continuous music
play, dependent on type of cell or smart phone used, and noise environment where eyewear is worn.
Your eyewear will remain in standby for about 7 days, when it is not used for talk or to play music.
A normal full charge takes about 2 ½ hours.
CHARGING YOUR EYEWEAR:
The eyewear must be turned off before charging.
Pull out the charging port cover located on the bottom of the right side of your eyewear, and plug the small end of your USB charging
cable into the port.
Plug the larger end of your USB cable into any USB port on your computer, or in your car.
Before fully charged, your eyewear's 'Function' button will glow red.
When fully charged, the 'Function' button will glow blue, or turn off completely.
Remove the USB cable, and firmly re-insert the charging port cover.
2
Advertisement
