Functional Description - Makita PC1100 Instruction Manual

Failure to do so may result in serious injury or
death to operator or anyone nearby.
6. Check the offset diamond wheel carefully for
cracks or damage before operation. Replace
cracked or damaged wheel immediately.
7. Before using the tool on an actual workpiece,
let it run for a while, keeping it away from your
body. Watch for vibration or wobbling that
could indicate poor installation, a poorly
balanced wheel, or a damaged wheel.
8. Hold the tool firmly with both hands during
operation.
9. Do not leave the tool running unattended.
Operate the tool only when handheld. Do not
fasten or mount the tool to a bench, table or
vise and then introduce workpieces to the tool.
10. Do not touch the offset diamond wheel
immediately after
extremely hot and could burn your skin.
11. Do not bear down on tool. Work the tool away
from and toward you without bearing down on
it. Otherwise the planer will leave marks on the
surface, the motor speed will drop and suction
efficiency will decrease.
SAVE THESE INSTRUCTIONS.
WARNING:
MISUSE or failure to follow the safety rules stated in
this instruction manual may cause serious personal
injury.

FUNCTIONAL DESCRIPTION

CAUTION:
Always be sure that the tool is switched off and
•
unplugged before adjusting or checking function on
the tool.
Switch action
1
2
004759
operation; it may
1. Switch trigger
2. Lock button
CAUTION:
Before plugging in the tool, always check to see
•
that the switch trigger actuates properly and
returns to the "OFF" position when released.
Switch can be locked in "ON" position for ease of
•
operator comfort during extended use. Apply
caution when locking tool in "ON" position and
maintain firm grasp on tool.
To start the tool, simply pull the switch trigger. Release
the switch trigger to stop.
For continuous operation, pull the switch trigger and
then push in the lock button.
To stop the tool from the locked position, pull the switch
trigger fully, then release it.
Level planing
To level a surface, the base of the planer should be
aligned with the diamond wheel. The front roller should
be
be adjusted (use hex wrench) upward to the level
required for the desired stock removal amount.
1
2
004760
To change the amount of stock (concrete) removed,
loosen the hex socket head bolts on the grip holder with
the hex wrench. Raise or lower the front roller to adjust
the gap between it and the diamond wheel. The
difference is the stock removal amount. Then secure the
hex socket head bolts very carefully.
1
2
004761
NOTE:
Maximum stock removal should be less than 2.5
•
mm (3/32").
4
1. Front roller
2. Hex wrench
3. Base
3
1. Hex socket
head bolt
2. Stock removal
amount