General Specifications - Yamaha O2R Owner's Manual

192 Specifications

General Specifications

Number of scene memories
Sampling frequency
Signal delay
Fader resolution
Total harmonic distortion (THD)
Frequency response
Dynamic range
Hum & Noise (20 Hz to 20 kHz) *,
Rs = 150 , Input gain max.
Input pad = 0 dB
Input sensitivity = -60 dBv
Maximum Voltage Gain
Crosstalk(@1kHZ)
Hum &Noise are measured with a 6 dB/octave filter @12.7 kHz; equivalent to a 20 kHz filter with an infinite dB/oc-
*
tave attenuation.
* Sampling Frequency: Internal 48 kHz
Digital Recording Console 02R
64
44.1 kHz, 48 kHz
Internal
External
(32 kHz -6%) to (48 kHz +6%)
Less than 2.5 ms. MIC/LINE input to STEREO output.
dB (128 steps/100 mm) input faders.
+10 to -90-,
0 to -120, dB (128 steps/100 mm ) stereo fader.
Less then 0.2%, 20 Hz to 20 kHz (analog output) @+14 dB into
600
+1, -3 dB, 20 Hz to 20 kHz @ +4 dB into 600
110 dB typical D/A Converter (STEREO OUT). *
105 dB typical A/D to D/A (MIC/LINE IN to STEREO OUT). *
-128 dB Equivalent input noise.
-88 dB residual output noise. STEREO OUTPUT. STEREO OUT-
PUT off.
-88 dB (92 dB S/N) STEREO OUTPUT. Master fader at nominal lev-
el and all channel faders at minimum level.
-64 dB (68 dB S/N) STEREO OUTPUT. Master fader at nominal lev-
el and all channel faders at nominal level.
74 dB MIC/LINE (1 through 16) IN to STERO OUT
74 dB MIC/LINE (1 thorugh 16 IN to AUX SEND 1, 2, 3, 4, 5, 6, (via
PRE INPUT FADER)
74 dB MIC/LINE (1 through 16) IN to MONITOR OUT (via STERO
b u s )
54 dB LINE (17 through 24) IN to STEREO OUT
70 dB adjacent input channels.
70 dB input to output.
User's Guide
.