Maintenance; Replacing Filter; Replacing Carbon Brushes; Operation - Makita UT2204 Instruction Manual

1
3
007102
Insert the mixing blade into the shaft and secure it with
the hex bolt.
At this time, position it so that the top end of the hex bolt
always fits to the flat surface on the shaft and tighten the
hex bolt with the provided wrench.
When installing the mixing blades at two different
positions (which is applicable only to the mixing blades
allowed to do so), mount and secure the two mixing
blades on the flat part of the shaft with the hex bolts so
that the same surface of blades faces each other as
shown in the figure.
007103
007104

OPERATION

Mixing
CAUTION:
Do not use to mix flammable material such as paint
•
with thinner used as solvent. Failure to do so may
cause injury.
1. Hold the rear handle of the tool with one hand and
the grip with the other hand
mixing blade under material fully and turn on the
tool after making sure work site safety.
2. Move the mixing blade up and down during the
mixing operation so that whole part of material can
1. Hex bolt
2. Shaft
2
3. Flat surface
1. Mixing blade
1
2. Shaft
2
1. Hex bolt
1
2. Shaft
3. Flat surface
2
3
firmly, place the
be mixed.
3. When finishing mixing, turn off the tool, make sure
that the mixing blade has come to a complete stop,
and then pull it out of the vessel.

MAINTENANCE

CAUTION:
Always be sure that the tool is switched off and
•
unplugged before attempting to perform inspection
or maintenance.
Never use gasoline, benzine, thinner, alcohol or the
•
like. Discoloration, deformation or cracks may
result.

Replacing filter

1
007098
Replace the filter regularly as the cooling efficiency of the
tool is reduced due to built-up dust or particles in the
filter.
Insert the slotted bit screwdriver and the like between the
tool and the cover as shown in the figure. Lift it up just like
using a shovel and remove the cover.
Replace the filter in the cover with a new one.
Reinstall the cover on the tool.

Replacing carbon brushes

001145
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
Use a screwdriver to remove the brush holder caps. Take
out the worn carbon brushes, insert the new ones and
secure the brush holder caps.
5
1. Filter
2
2. Cover
3. Screwdriver
3
1. Limit mark
1