Draytek Vigor 2130 Series User Manual page 137

Destination IP
Destination Subnet
Source Start Port
Source End Port (optional)
Destination Start Port
Destination End Port
(optional)
Action
E x a m p
E x a m p
Refer to the following example.
1. Use TSPC mode to connect to IPv6 network.
PC get ipv6 IP: 2001:5c0:1503:7400:30e4:139d:53c8:3a1e
2. Connect PC to http://www.ipv6.org/ with IPv6 IP address.
A message will appear from the web page:
3. Set firewall rule to block all TCP traffic from this IP address.
4. Open IPv6 >> IPv6 Firewall Setup and press Add New Rule.
Vigor2130 Series User's Guide
l e :
l e :
Welcome to the IPv6 Information Page!
You are using IPv6 from 2001:5c0:1503:7400:30e4:139d:53c8:3a1e
Type the IP address here if you choose Single as
Destination IP Type.
Type the subnet mask here if you choose Subnet as
Destination IP Type.
Type a value as the source start port. Such value will be
available only TCP/UDP is selected as the protocol.
Type a value as the source end port. Such value will be
available only TCP/UDP is selected as the protocol.
Type a value as the destination start port. Such value will be
available only TCP/UDP is selected as the protocol.
Type a value as the destination end port. Such value will be
available only TCP/UDP is selected as the protocol.
Set the action that the router will perform for the packets
through the protocol of IPv6.
Accept – If the IPv6 packets fit the condition listed in this
page, the router will let it pass through.
Drop - If the IPv6 packets fit the condition listed in this
page, the router will block it.
127