Makita BTP140 Instruction Manual page 7

Cordless 4 mode impact driver

Hide thumbs Also See for BTP140:

Table of Contents

1. Action mode changing lever

CAUTION:

•

Always check the direction of rotation before operation.

•

Use the reversing switch only after the tool comes to a complete stop.

Changing the direction of rotation before the tool stops may damage the

tool.

•

When not operating the tool, always set the reversing switch lever to the

neutral position.

Selecting the action mode

This tool employs an action mode changing lever. Select one of the four

modes suitable for your work needs by using this lever.

For rotation with impact, turn the lever so that the arrow on the lever points

007158

toward the

For rotation with hammering, turn the lever so that the arrow points toward the

007159

mark on the tool body.

For rotation with clutch, turn the lever so that the arrow points toward the

007160

mark on the tool body.

For rotation only, turn the lever so that the arrow on the lever points toward the

007161

mark or the

mark on the tool body.

Table of Contents

Btp130