Patrol Setting; Pan-Tilt Scanner - Linksys LCAD03FLN User Manual

Linksys

Patrol Setting

NOTE:
(Only available with models with a RS485 interface) – Patrol Setting only
works if a pan-tilt scanner is connected to the camera's RS485 interface.
This feature can ONLY be displayed correctly on Internet Explorer.
The camera can be set to patrol a group of preset points. For each patrol group,
the user can configure the preset point order, movement speed, and viewing
duration.
How to create a patrol group
1. Click Add to create a new patrol group.
2. Enter description for this new patrol group.
3. Use the right arrow buttons to add preset positions into the group.
4. Use up and down arrow buttons to change the order of preset positions
in the group.
5. You can specify movement speed, viewing duration for each preset position
in the group.
6. Click Apply.
7. To start a patrol group, click Start in the patrol group list.
NOTE:
A total of sixteen preset points can be assigned to a patrol group, and a
total of four patrol groups can be assigned to a network camera.

Pan-Tilt Scanner

NOTE:
(Only available with models with a RS485 interface) – Pan-Tilt Scanner
only works if it is connected to the camera's RS485 interface. This feature
can ONLY be displayed correctly on Internet Explorer.
Enabled - Click check box.
Baud Rate/Protocol - Baud rate and protocol values of the video server must
be set to match the baud rate and protocol values of the scanner. See the
scanner user manual for the baud rate and protocol configuration details
Camera ID - Enter a camera or scanner ID.
Configuration
8