Camera Installation - Honeywell VSD-361P Operation Manual

2.3 Camera Installation

2.3.1 Ribbon cable：Insert FPC socket of the cable to the relevant port of the base plate on the dome control board. (Ribbon
cable has length of 65MM and 110MM, user can select the ribbon cable according to different models of the camera)
Figure 4
below illustrates the writing configuration of the ribbon/cable.
2.3.2 Install the camera module:
as illustrated in Fig. 6 and Fig. 7.
Attention: Take care not to scratch the lens when installing the camera. Do make sure the camera model is the right
one for installation. Secure the camera to the corresponding screw holes as illustrated in Fig. 6, according to the
model and make of the camera, as different camera models may have different dimensions. Following the
installation of the camera module verify that it does not touch any of the dome parts including the camera shroud
and acrylic dome by gently moving the camera module along the vertical axis.
FP C
C on n e c to r
F FC
F l e xi bl e F l a t C a bl e
FP C
C on n e c to r
4 -PW M2 *6
Install the camera module on the vertical axis tray of the dome
Sony camera model screw holes
Honeywell camera model screw holes
Install the camera module on the vertical axis
Fig.6
tray of the dome as illustrated in Fig.7 using the
4 supplied PWM2*6 Screws.
Fig.3
Fig.4
Output of ribbon cable
Fig.5
4
Insert the camera ribbon to the camera
FPC Socket to secure the connection.
Fig.7