Makita LS0714 Instruction Manual page 20

1
2
(2) 45° bevel angle
Adjust the 45° bevel angle only after perform-
ing 0° bevel angle adjustment. To adjust left
45° bevel angle, loosen the lever and tilt the
blade to the left fully. Make sure that the
pointer on the arm points to 45° on the bevel
scale on the arm holder. If the pointer does
not point to 45°, turn the 45° bevel angle
adjusting bolt (upper bolt) on the right side of
the arm until the pointer points to 45°.
Adjusting the position of laser line
For model LS0714FL only
1
3
1
2
003944
1. Bevel scale
3
2. Pointer
3. Screw
003945
1. Left 45 degrees
bevel angle
adjusting bolt
1
005701
1. Work piece
2. Cutting line
3. Holder assem-
bly (optional
accessory)
2
005702
1. Vertical vise
2. Holder assem-
bly (optional
accessory)
WARNING:
• As the tool is plugged when adjusting the position
of laser line, take a full caution especially at switch
action. Pulling the switch trigger accidentally cause
an accidental start of the tool and personal injury.
CAUTION:
• Never look into the laser beam directly. Direct laser
beam causes damage to your eyes.
• Never apply a blow or impact to the tool. A blow or
impact causes the incorrect position of laser line,
damage to the laser beam emitting part or a short
life of the tool.
When adjusting the laser line appears on the left side
of the saw blade
1
1. Screw to change the
movable range of the
adjusting screw
3. Hex wrench
5. Saw blade
When adjusting the laser line appears on the right
side of the saw blade
1
1. Screw to change the
movable range of the
adjusting screw
3. Laser line
For both adjustments, do as follows.
1. Make sure that the tool is unplugged.
2. Draw the cutting line on the workpiece and place it
on the turn table. At this time, do not secure the
workpiece with a vise or similar securing device.
3. Lower the blade by lowering the handle and just
check to see where the cutting line and the position
of the saw blade is. (Decide which position to cut on
the line of cut.)
4. After decision the position to be cut, return the han-
dle to the original position. Secure the workpiece
with the vertical vise without shifting the workpiece
from the pre-checked position.
20
2
4
3
2. Adjusting screw
4. Laser line
2
2. Saw blade
005527
5
005528
3