Cleaning & Maintenance - Honeywell CL15AM Owner's Manual

IMPORTANT
•
The cooler is supplied with Honeycomb Cooling Media.
•
The cleaning frequency for the Honeycomb media depends on local air and water
conditions. In areas where the mineral content of water is high, mineral deposits may build up
on the Honeycomb Cooling Media and restrict air flow. Draining the water reservoir and refilling
with fresh water at least once a week will help reduce mineral deposits. If mineral deposits
remain on the Honeycomb media, the media should be removed and washed under fresh water.
The media should be cleaned every two months or sooner, depending on your needs.
•
Do not run the unit in COOL mode with stale water in the tank. Empty the tank and refill it with
fresh water if the water has been standing in the tank for an extended period of time.
•
For best results, allow the Honeycomb Cooling Media to dry after each use by turning off the
cool function 15 minutes before turning the unit off.
•
Draining the water reservoir and refilling with fresh water at least once a week will greatly
reduce mineral deposits in the pads and help to extend the life of Honeycomb Cooling Media.
WARNING
•
Before cleaning the unit, switch it to the ''off'' position and remove the plug from the power socket.
•
To clean the outside, use a damp cloth to remove dirt and dust.
•
Never use corrosive elements or any chemicals to clean this product.
•
When the product is not in use, store the unit in a dry place out of direct sunlight.
CLEANING & MAINTENANCE
11