Filling Water - Honeywell CL15AM Owner's Manual

USE & OPERATION
CAUTION
Unplug from power when refilling.

FILLING WATER

Unplug the air cooler from power supply.
Check water level indicator located on the front of the unit to
determine the level of water inside the water tank. The water
tank of this cooler holds up to 15 Litres of water. Please be
sure water in the tank is always above minimum water level
mark.
To refill the water tank, open the Water Fill Door located below
the left side panel (see page 7) and fill water to the Max Level,
as indicated on the Water Level Indicator. Do not fill water
above the Max water level mark.
After refilling the water tank, close the water fill door, connect the power supply and turn on.
Note :
Running the unit with inadequate water may cause pump failure.
ASSEMBLY INSTRUCTIONS FOR CASTOR WHEELS.
Note:
Back wheel castors do not
come pre-installed in this unit.
Please follow instructions as
shown in Fig 1, 2 & 3 for
installing the castor wheels.
10
Fig. 1
Water Fill Door
Fig. 2
Fig. 3