Installing Abrasive Disc - Makita BBO140 Instruction Manual

Speed mode Number of rotations
High
Middle
Low
012897
NOTE:
The table shows standard applications. They may
•
differ under certain conditions.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before carrying out
any work on the tool.

Installing abrasive disc

1
012875
To install the abrasive disc, first remove all dirt or foreign
matter from the pad. Then attach the abrasive disc to the
pad. Be careful to align the holes in the abrasive disc with
those in the pad.
Installing dust bag (optional accessory)
1
012876
Install the dust bag on the tool with its mouth directing
downwards.
Usage
Regular
11,000
sanding
Finish
9,500
sanding
7,000 Polishing
1. Pad
2. Abrasive disc
2
1. Dust bag
Emptying dust bag
1
003323
When the dust bag is about half full, switch off the tool,
and remove the dust bag from the tool. Then remove the
dust nozzle from the dust bag after unlocking the dust
nozzle by turning it slightly counterclockwise. Empty the
dust bag by tapping it lightly.
1
003326
After emptying the dust bag, install the dust nozzle on the
dust bag. Turn the dust nozzle slightly clockwise to lock it
in place. Then install the dust bag on the tool as
described in "Installing dust bag".
Installing paper filter bag (Optional
accessory)
009094
Make sure that the logo on the cardboard lip and the logo
on the dust box are on the same side, then install the
paper filter bag by fitting the cardboard lip in the groove
of each holding tab.
6
1. Dust nozzle
1. Dust nozzle
1. Holding tab
1