Sanding Operation - Makita BBO140 Instruction Manual

009095
Make sure that the logo on the cardboard lip and the logo
on the dust nozzle are on the same side, then install the
dust nozzle on the dust box.
Removing dust box and paper filter bag
2
1
009092
Remove the dust nozzle by pushing the two latches.
009093
Remove the paper filter bag first by pinching the logo
side of its cardboard lip, then by pulling the cardboard lip
downwards to move it out of the holding tab of the dust
box.
Removing and reinstalling the skirt
CAUTION:
Do not use the tool without the skirt. Otherwise dust is
scattered all over.
012881
1. Dust box
2. Dust nozzle
1
2
1. Latch
2. Dust nozzle
You can choose one of 12 directions of the skirt in
accordance with your purpose.
1
012885
To remove the skirt, remove the screw and remove the
skirt with slightly opening it for both sides.
012945
To reinstall the skirt, install it with slightly opening it for
both sides. And fasten the screw.
CAUTION:
Do not set the skirt other than the designated angle.
Otherwise the tool may be damaged.
OPERATION
WARNING:
Never switch on the tool when it is in contact with the
workpiece, it may cause an injury to operator.

Sanding operation

012879
CAUTION:
Never run the tool without the abrasive disc. You
•
may seriously damage the pad.
Never force the tool. Excessive pressure may
•
decrease the sanding efficiency, damage the
abrasive disc or shorten tool life.
7
1. Skirt
2. Screw
2
1. Skirt
1