Low-Profile boards
Installing and removing drives
The server casing can accommodate a total of eight drives:
•
four accessible drives
(three 5¼" drives and one 3½" drive)
•
four non-accessible drives
(3½" drives)
"Accessible drives" are e.g. DVD or CD ROM drives, into which a data carrier can be inserted from
outside. Non-accessible drives are e.g. hard disk drives.
IDE drives
Four IDE drives are supported as standard equipment. Ideally, hard disk drives are connected to
IDE interface 1 and other drives to IDE interface 2 (see also the technical manual for the system
board).
SCSI drives
If you want to install a SCSI drive, you require a SCSI controller and a SCSI cable. Details are
provided in the manuals on the SCSI controller
Removing the front panel
Ê
Open the casing (see "Opening the casing").
Ê
Detach the unlocking lever (1) and open the front panel (2).
Ê
Detach the plastic hook on the front panel of the casing and carefully remove the front panel. If
you pull too hard, you may loosen or damage the LCD cable.
A26361-K831-Z102-1-7619
1
1
2
System expansions
43