Operation; Switching The Server On; Switching The Server Off - Fujitsu PRIMERGY ECONEL 30 Operating Manual

Operation

Switching the server on

Ê
If necessary, switch the monitor on (see the operating manual for the monitor).
Ê
Switch the server on with the main switch at the rear of the server.
Ê
Press the ON/OFF button on the front of the server.
The power-on indicator lights green (see "Indicators on the server" chapter) and the server is
started.

Switching the server off

Ê
Shut down the operating system properly.
Ê
If the server operating system does not switch off automatically, use the ON/OFF button to
switch off the server when requested.
Switch the server off at the main switch.
CAUTION!
!
The main switch and the ON/OFF button do not disconnect the server from the mains
voltage. To completely disconnect the mains voltage, remove the power plug from the
socket.
Ê
If necessary, switch the monitor off (see the operating manual for the monitor).
Placing a server (with soft power off function) in a ready-to-operate state by means of
software
With the soft power off function the server automatically switches off (standby) or switches into the
energy-saving mode after the operating system is shut down. Requirements: Your system must
support switching off with software and this functionality must be enabled in BIOS Setup. The soft
power off software may also need to be installed on Windows NT systems.
You can also switch your server into the standby mode via ServerView- and/or RemoteView.
A26361-K831-Z102-1-7619
23