Time And/Or Date Is Not Correct; Error Messages On The Screen; Restoring The Hard Disk Contents; Tips - Fujitsu PRIMERGY ECONEL 30 Operating Manual

Table of Contents

Advertisement

Troubleshooting and tips

Time and/or date is not correct

You can set the time and date in the BIOS Setup or in the operating system.
Ê
Set the time and date.
If the time and date are repeatedly wrong when you switch on your server, the on-board
i
battery is flat. Change the lithium battery as described in the "Extensions to the system
board" - "Replacing lithium battery" chapter.

Error messages on the screen

Error messages and their explanation are contained:
in the technical manual for the system board
in the "BIOS Setup" manual
in the documentation for the programs used

Restoring the hard disk contents

Should you need to restore your hard disk, the instructions are provided on the case of the
"Recovery CD" (delivered with your system).

Tips

The server cannot be switched off with the ON/OFF button
Cause: The server has not been switched on with the ON/OFF button.
Ê
Press the ON/OFF button again.
Cause: System crash
Ê
Press and hold the ON/OFF button for at least four seconds until the server switches off.
Out of system resources
If you have too many applications running at once, you may experience problems due to a lack of
system resources. In this case you should:
Ê
close unnecessary applications
or
Ê
run the applications in a different order
Other manuals
Other manuals are contained on the "Drivers & Utilities" CD.
34
A26361-K831-Z102-1-7619

Advertisement

Table of Contents
loading

Table of Contents