Download Print this page

Additional Safety Rules - Makita LSl030N Instruction Manual

Miter saw 255 mm (10”) equipped with electric brake

Advertisement

VOLTAGE WARNING: Before connecting the tool t o a power source (receptacle,
outlet, etc.) be sure the voltage supplied is the same as that specified on the
nameplate of the tool. A power source with voltage greater than that specified
for the tool can result in SERIOUS INJURY t o the user
-
as well as damage to
the tool. If in doubt, DO NOT PLUG IN
THE TOOL. Using a power source
with
voltage less than the nameplate rating is harmful t o the motor.
ADDITIONAL SAFETY RULES
1. Wear eye protection.
2. Do not operate saw without guards in place.
3.
Don't use the tool in the presence of flammable liquids or gases.
4. Check the blade carefully for cracks or damage before operation.
5. Use only flanges specified for this tool.
6. Be careful not to damage the arbor, flanges (especially the installing surface)
7. Make sure that the turn base is properly secured so
it
will not move during
8.
For your safety, remove the chips, small pieces, etc. from the table top before
9. Avoid cutting nails. Inspect for and remove all nails from the workpiece before
Replace cracked or damaged blade immediately.
or bolt. Damage t o these parts could result in blade breakage.
operation.
operation.
operation.
IO.
Make sure the shaft lock is released before the switch is turned on.
11.
Be sure that the blade does not contact the turn base in the lowest position.
12. Hold the handle firmly. Be aware that the saw moves up or down slightly
during start-up and stopping.
13. Do
not perform any operation freehand. The workpiece must be secured
firmly against the turn base and guide fence during all operations.
14. Keep hands out of path of saw blade. Avoid contact with any coasting blade.
It
can still cause severe injury.
15. Never reach around saw blade.
16. Make sure the blade is not contacting the workpiece before the switch is
turned on.
17. Before using the tool on an actual workpiece, let
it
run for a while. Watch
for vibration or wobbling that could indicate poor installation or a poorly
balanced blade.
18. Wait until the blade attains full speed before cutting.
19. Stop operation immediately if you notice anything abnormal.
20. Do not attempt t o lock the trigger in the on position.
5

Advertisement

loading

This manual is also suitable for:

Ls1030n