12.6.5 Duct
•
Remove the work top.
•
Remove the rear panel.
•
Remove the drum.
•
Unscrew the screws which secure it to the hinges and hinge hole masking plates.
•
Extract the duct.
From the duct, it is possible to access the lamp-holder and the relevant wiring (models with drum light).
12.6.6 Duct rollers
•
Remove the work top.
•
Remove the rear panel.
•
Remove the drum.
•
Remove the screws (d) which secure them to
the duct.
12.6.7 Front and rear seals
•
Remove the work top.
•
Remove the rear panel.
•
Remove the drum.
•
The rear seal (i) can be simply pulled away
from the ring fitted to the rear panel.
•
Slide out the front seal from its seat.
Notes for replacement of the rear drum seal
1. Position of the seal joint.
2. Position of the compensation hole.
3. After replacing the rear drum seal, apply some
lubricant uniformly over the entire inner felt
surface using 8 gr of silicone oil (part no. 5023
72 70-00/9.
3
SOI/ADL
Surface to
be
lubricated
53/57
3
i
d
d
599 38 46-21