1 Purpose of this Manual
The purpose of this Service Manual is to provide service engineers who already have the basic knowledge
necessary to repair dryers with information concerning condenser dryers with electronic control systems ENV 06
with anti-crease system CRM produced in the factory of Siewierz (Poland).
The control system features two PCBs: a main one featuring an integrated selector and LCD display,
supplied already mounted and tested by the building factory and a control board of the CRM system.
This Service Manual describes the following aspects:
•
General characteristics
•
Control panel and drying programmes
•
Technical characteristics
•
Accessibility
•
Diagnostics guide
2 IMPORTANT
Repairs to electrical appliances must be carried out only by qualified service engineers.
Before touching internal components, always remove the plug from the power socket.
WARNING
2.1 Installation
The appliance must be installed on a perfectly level surface in order to ensure that the condensed water
flows correctly into the tank.
The feet must NOT be removed. The gap between the bottom of the dryer and the floor is essential to
prevent overheating.
SOI/ADL
4/57
599 38 46-21