Notes About This Recorder; Specifications - Sony SVR-HD700 Operating Instructions Manual

Notes About This Recorder

On operation
If the recorder is brought directly from a cold to a
warm location, or is placed in a very damp room,
moisture may condense inside the recorder.
Should this occur, the recorder may not operate
properly. In this case, leave the recorder turned on
for about half an hour until the moisture
evaporates.
On adjusting volume
Do not turn up the volume while listening to a
section with very low level inputs or no audio
signals. If you do, the speakers may be damaged
when a peak level section is played.
On cleaning
Clean the cabinet, panel, and controls with a soft
cloth slightly moistened with a mild detergent
solution. Do not use any type of abrasive pad,
scouring powder or solvent such as alcohol or
benzine.
About repairing the hard disk drive
• It may be necessary to access data stored on the
hard disk for testing purposes; there is no
intention to copy or store the data, titles or any
other information.
• If replacement or initialization (format) is
required, the hard disk will be formatted at our
discretion. In this case, please note that all of the
contents recorded there will be erased (including
any data found to violate copyright law).
50

Specifications

System
Transmission standards: DVB-T
Channel coverage: 51 - 858 MHz
The above channel coverage merely ensures the
channel reception within these ranges. It does not
guarantee the ability to receive signals in all
circumstances.
Aerial out: 75-ohm asymmetrical aerial socket
Video format: MP@ML, MP@HL
Audio format: Dolby Digital, MPEG (I and II)
Outputs
AUDIO OUT: Phono jacks (2 each)/2 Vrms/10
kilohms
VIDEO OUT: Phono jack/1.0 Vp-p/75 ohms
S VIDEO OUT: 4-pin mini DIN/Y:1.0 Vp-p,
C: 0.3 Vp-p (PAL)/75 ohms
DIGITAL AUDIO OUT (OPTICAL): Optical
output jack/–18 dBm (wave length: 660 nm)
DIGITAL AUDIO OUT (COAXIAL): Phono
jack/0.5 Vp-p/75 ohms
COMPONENT VIDEO OUT
(Y, P /C , P /C
B B R R
Phono jack/Y: 1.0 Vp-p, P
P /C : 0.7 Vp-p/75 ohms
R R
HDMI OUT:
Type A (19-pin)
):
/C : 0.7 Vp-p,
B B