Levelling The Appliance And Adjusting The Doors; Fitting The Front Cover - Baumatic TITAN4 Instruction Manual

o Check thoroughly for any leaks.
IMPORTANT- If there are any signs of water leaks, you should follow
the installation procedure stage by stage again.

Levelling the appliance and adjusting the doors

The appliance must be situated on a level and even floor; otherwise
the doors may not hang properly or seal correctly.
The front of the appliance should be a little higher than the
rear of the fridge freezer. This will allow for easy closing of
the doors. However if you raise the front of the appliance
too high, then you may find it difficult to open the doors.
Levelling the freezer door
o Turn the screwdriver anti-clockwise to lower the freezer door.
Levelling the fridge door

Fitting the front cover

This step should only be done after the appliance is in position and
levelled off.
o Remove the screws from the front bottom panel.
o Use these screws to fix the front cover to the appliance.
o Insert a flat tipped screwdriver into the
groove of the left hand front wheel.
o Turn the screwdriver clockwise to raise the
freezer door.
o Insert a flat tipped screwdriver into the
groove of the right hand front wheel.
o Turn the screwdriver clockwise to raise
the fridge door.
o Turn the screwdriver anti-clockwise to
lower the fridge door.
35