Connecting The Water Inlet Hose And Water Filter - Baumatic TITAN4 Instruction Manual

Connecting the water inlet hose and water filter

1) Connection the water inlet hose to the connector on the rear of the
appliance.
o Ensure that the water tap which the inlet hose is connected to is
fully open.
o Select the water dispensing option and run it for 2 – 3 minutes,
this supplies water to the water tank and will eventually dispense
water.
IMPORTANT- The running of water through the inlet hose and filter
must be done,
manufacturing process are washed out.
to make sure
2) Place the seal
connector A and then screw
connector A securely onto your
cold water mains supply. Push
the water inlet hose firmly onto
connector A.
that any impurities
inside of
from the
34