Character Activation Timeout
You can set a timeout for the length of time the illumination remains on and
attempting to decode bar codes when using Character Activation Mode.
Set the length (in milliseconds) for a timeout by scanning the following bar
code, then setting the timeout (from 1-300,000 milliseconds) by scanning
digits from the
then scanning Save. Default = 30,000 ms.
Deactivation Character
This sets the character used to terminate scanning when using Character
Deactivation Mode. On the
1252), page A-4, find the hex value that represents the character you want
to use to terminate scanning. Scan the following bar code, then use the
Programming Chart
that ASCII character. Scan
Reread Delay
This sets the time period before the scanner can read the same bar code a sec-
ond time. Setting a reread delay protects against accidental rereads of the
same bar code. Longer delays are effective in minimizing accidental rereads.
Programming Chart
Character Activation Timeout
ASCII Conversion Chart (Code Page
to read the alphanumeric combination that represents
Save
Deactivation Character
* End Character Activation After
inside the back cover of this manual,
to finish.
Good Read
3 - 15