NOTE:
Figure 17
illustrates how to attach the plenum to the 4/8 or 4/16 SAN Switch
specifically. If installing the plenum on the 4/32B SAN Switch, the procedure and
figure also applies.
3
Figure 17 Attaching the Plenum to the 4/8 or 4/16 SAN Switch
1. Plenum
3. Two screws for attaching plenum to rails
Securing the switch to the outer rails
To secure the switch to the outer rails:
1.
Insert the switch with the attached inner rails into the outer rails.
NOTE:
This step applies to installing a switch in HP 9000 Series, HP 10000
Series or HP System/e racks.
2.
Insert the device into the rack and install (2) #10-32 x 1/2-inch Phillips pan-head
screws with captive star lock washers with one on each side. See
Figure
50
Installing and configuring SAN Switches
1
19.
2
25052a
2. SAN Switch
Figure 18
and