Installing The Switch As A Stand-Alone Device - HP AA-RWF3A-TE Installation Manual

• Ensure that the ambient air temperature does not exceed 40 ºC (104 ºF) while
the switch is operating.
NOTE:
Do not block air vents. The switch uses ambient air for cooling.

Installing the switch as a stand-alone device

To install the switch as a stand-alone unit:
1. Unpack the switch and verify that all items listed in
contents
2.
Locate the four rubber feet in the accessory box.
3. Apply the adhesive rubber feet to the switch. The rubber feet help prevent the switch
from sliding off the supporting surface:
a. Clean the indentations at each corner of the bottom of the switch to ensure that
they are free of dust or other debris that might lessen the adhesion of the feet.
b. With the adhesive side against the chassis, place one rubber foot in each
indentation and press into place.
4.
Place the switch on a flat, sturdy surface.
5.
Apply power to the switch as described in
CAUTION:
Do not connect the switch to the network until the IP address is set. For instructions on
setting the IP address, see
40
Installing and configuring SAN Switches
on page 35 are present.
Cabling and configuring the SAN Switch
Shipping carton
Powering on and off
on page 52.
on page 66.