Advertisement
Starting and Driving
1. before starting, you should check the vehicle and road conditon;
2. turn on, check the battery power, lights, horn, brake, tyres and so on;
3. push off the side stand, seat on saddle, turn the throttle slowly.
Attention when driving
You should pedal when you ride uphill or against head wind in order to decrease the
discharge current and protect the battery.
It is prohibited to ride when the surface water is over
the outer edge of the motors. It will damage
the controller and motor.
Trouble Shooting
Problems
Cannot charge the battery
Turn on, this is no power
Turn on, LEDs indicate the power
but the motor does not work
After fully charging, the range is
short
Controller spec. and how to work
1. Basic Specs.
Type: 1B100-D01A-1A00
Voltage: DC48V
Holzer phase: 120 Degree
Max current:15+-1A
2. This controller is specifically designed for
electric bicycle. It has a single smart chip
inside, control the speed, brake power,
overvoltage protection, current limiting
protection, speed limits, anti-coaster protection
and temperature protection. it is reliable to
ensure that electric bicycle drive system in the
best condition to work.
3. No necessary daily maintenance but be sure
Reasons
1. poor connection between the charge
plug and battery socket, conductor
disconnection.
2. the wires between batteries set drop re-connect the wires.
3. charger problem
4. fuse broken
1. fuse broken
2. the battery plugs poor contact
3. the switch is wrong or conductor
poor contact
1. throttle has problem
2. power brake mulfunction
3. controller has problem
4. motor has problem
1. Insufficient power
2. Battery performance degradation
3. The pressure of tyre is insufficient
4. the brakes are misadjusted
5. front/rear wheel stagnation
Trouble shooting
re-connect the conductor or
weld the wire.
repair or change new one
change new one
change new one
repair or re-connect
change power switch or
check the conductor
change a new one
change a new one
change a new one
repair or change a new one
check whether the
connector is well contacted
change a new set
tire inflation
adjust the brake distance
lubricate, adjust or change
the axle bearing
Advertisement
