Loading And Unloading The Cassette Tape - Honeywell HR24TLX Installation Manual

Video cassette tapes can be loaded into your new VCR as long as the VCR is plugged into a
power source. Even if the VCR power switch is turned off, loading a cassette will
automatically cause it to turn on. Use only standard video cassette tapes.
Use only standard grade cassette tapes for reliable video recording. Please do not use : Pro,
Hi-Fi and High Grade tapes as damage to the video heads may occur.
FF
peeled, causing noise or poor quality picture. The tape may droop and cause troubles. Dusty
tape causes troubles. Unevenly wound tape may be damaged. Wind such tape evenly by
FF
1. To position the cassette properly before
2. Gently insert the video tape into the cassette
1. Press the EJECT button on the front of the VCR.
2. Remove the cassette.
Your VCR will eject a video cassette even if it is in Standby mode. When the EJECT button is
pressed, the VCR will automatically eject the tape.
It is not possible to eject a tape while recording without first pressing the stop button. A tape
cannot be ejected when the VCR is locked.
Video cassettes come with an erasure prevention tab which,
when removed, prevents the tape's contents from being
erased, or recorded over.
If the cassette you insert in your VCR has the erasure
prevention tab removed, your VCR will automatically eject it if
you attempt to record on it.
English-12

LOADING AND UNLOADING THE CASSETTE TAPE

Rewind before you use a new tape. If you use the same tape many times its magnet is
Rewind before using.
inserting it in the cassette slot, hold the
cassette so that the long narrow edge with
the contents label faces towards you. The
other long narrow edge is hinged and
should face towards the VCR.The clear
plastic window that shows the video tape
should face upward.
slot to a point where the VCR automatically
retracts the cassette.
* When you insert the videotape, be sure to orient it squarely to the slot.
TO PREVENT ACCIDENTAL ERASURE
LOADING
UNLOADING