Makita VC1310L Instruction Manual page 10

011608
Fit two protrusion of the pipe holder into the
grooves of the tank cover and then press
down the pipe holder.
1
011631
NOTE:
The pipe holder that is excessively
•
lowered than the intended position
cannot be installed on the cord hook
with the hook away from the tank cover
as shown in the figure.
1
2
011632
NOTE:
Make sure that the two hooks of the
•
pipe holder are hooked on the tank
cover securely.
Connecting a hose
CAUTION:
Never force the hose for bending or
•
stamp it. Never move the cleaner by a
hose. Forcing, stamping and pulling the
hose may cause a breakage or
deformation of the hose.
1. Tank cover
2. Hook
2
1. Tank cover
2. Hook
When picking up large wastes such as
•
planer carvings, concrete dusts or
similars other than small wastes, use
the 38 mm inner diameter hose
(optional accessory). Using the 28 mm
inner diameter hose may cause a hose
stuffing and damage.
011590
Insert the hose onto the mounting port of the
tank and turn it clockwise until it locks.
Installing polyethylene bag
Cleaner can
polyethylene
polyethylene bag is easier to empty the tank
without letting your hands dirty.
1
011591
Spread the polyethylene bag in the tank.
Insert it between the holder plate and the
tank, and pull it to the hose inlet.
1
011592
Spread the bag around the top of the tank.
Hook up the other side of the bag around the
top of the tank so that the prefilter hook can
catch and hold it securely
10
also be used
bag. However,
1. Holder plate
2. Tank
2
1. Polyethylene
2
bag
2. Holder plate
3. Tank
3
without
using