Adjusting The Parallelism Of The Cutting Unit; Service Position For The Cutting Unit - Husqvarna 11 C Operator's Manual

Adjusting the parallelism of the
cutting unit
1 Check the air pressure in the tyres 60 kPa/0.6 kp/cm
PSI.
2 Remove the front cover.
3 Loosen the parallelism stay's nuts, the inner nut has a left-
hand thread.
4 Screw out (extend) the stay to raise the rear edge of the
cover. Screw in (shorten) the stay to lower the rear edge
of the cover.
5 Tighten the nuts after adjustment.
6 On completion of the adjustment the unit's parallelism
should be re-checked.
7 Fit the front cover.
30 –
English
Maintenance

Service position for the cutting unit

The cutting head can be placed in the service position to
provide easy access for cleaning, repairs and servicing. In the
2
/8.5
service position the cutting unit is raised and locked in the
vertical position.
Placing in the service position
Rider 11 C, 13 C, 16 C, 16 AWD
1 Position the machine on flat ground. Apply and lock the
parking brake. Set the cutting height control in the lowest
position and lift up the cutting unit.
2 Remove the front hood by removing the pin.
3 Loosen the spring on the drive belt's belt idler by
loosening the handle.