Reset The Unit - AEG SOLO 10 User Manual

17
>The last stored detect number is displayed (if any).
• Enter the number you want to be detected (maximum 5 digits) and then press
>A confirmation tone is played.
• Press to "PREFIX" and press
>The last stored prefix number is displayed (if any).
• Enter the number you want the detected number to be replaced with (maximum 10 digits) and then
press to confirm.
>A confirmation tone is played.
• Press to return to standby mode.
Note:
If the detect digit is not entered (blank), the prefix number will be automatically added to the pre-dial
number after T is pressed.
For numbers starting with *, # or P, the prefix number will not be added to the pre-dial number after T is
pressed.
14.6 Change the Recall Time
You may need to press F to send a Flash signal (also called Recall or Timed Break Recall) if you are
connected to a PBX. You should normally leave the Recall Time at its default setting, Short (100ms), as this
is the standard recall required in the telephone network. However, it can be changed to Medium (270ms)
or Long (600ms) if your telephone is connected to a PBX that requires a different recall time.
• From the home screen, press
• Press to "ADVAnCED SET" and then press
• Press to "RECALL TIME" and then press
• Press to select "SHORT", "MEDIUM" or "LOnG" and then press
>A confirmation tone is played.
• Press to return to standby mode.
14.7 Set the First Ring
If you have subscribed to Caller Line Identification service and do not wish to hear the phone ring before
the caller identification is displayed, you can set the "FIRST RInG" to "OFF".
• From the home screen, press
• Press to "ADVAnCED SET" and then press
• Press to "FIRST RInG" and then press
• Press to select "On" or "OFF" and then press
>A confirmation tone is played.
• Press to return to standby mode.
15

RESET THE UnIT

You can reset your phone to its default settings with this feature.
Note:
Upon reset, all your personal settings, call log and redial list entries will be deleted and the phone will
return to its default settings. However, your phonebook will remain unchanged after reset. Also, if you have
an answering machine model, any recorded messages will remain unchanged, while all other settings will
be reset.
• From the home screen, press
• Press to "ADVANCED SET" and then press
• Press to select "RESET" and then press
• Press again to confirm.
>A confirmation beep is played and the unit is reset to its default settings.
to select.
to select.
to select.
to select.
to select.
.
to select.
to select.
to confirm.
to confirm.
to confirm.