Cisco DVR Configuration Manual page 40

Chapter 2 Customizing DVR Services
10 Click Cancel to close the Set Up Package window and return to the Package List
window.
11 Click File and then select Close to close the Package List window and return to
the DNCS Administrative Console.
12 Refer to the hexadecimal conversion table in EID Conversion Table (on page 55)
to convert the EID from hexadecimal format to decimal format, and then write
the decimal format of the EID here: ____________________
13 Go to Adding the Stand-Alone Service to the SAM (on page 32).
Adding the Stand-Alone Service to the SAM
On the DNCS Administrative Console, click the Application Interface Modules
1
tab.
2 Click SAM Service. The SAM Service List window opens.
3 Click File and then select New. The Set Up SAM Service window opens.
Follow these instructions to enter data in the fields of the Set Up SAM Service
4
window:

Service Name: Enter a name for the service, such as Stand-Alone.

Short Description: Enter _SCIW.
Important: You must enter _SCIW for the Short Description. Otherwise, your
system will be unable to support stand-alone authorization.
 Long Description: Enter a long description for the stand-alone feature, such
as Stand-Alone Authorization. This information is for your use only.
Subscribers will not see the text that you enter here.
Note: You can enter up to 32 alphanumeric characters.

Application URL: Enter dummyURL;EID=#, replacing the # symbol with
the decimal equivalent of the EID belonging to the Stand-Alone package.
Notes:
–
–
32
To obtain this number, refer to step 12 of Adding a Package to Control
Subscriber Access to the Stand-Alone Mode (on page 31).
Entering this number limits Stand-Alone authorization only to
subscribers authorized for the stand-alone package.
4011411 Rev B