Basic Operation Of Dome Camera - Hitachi VK-S454ER User Manual

Auto Cruising
Auto cruising is the function of this dome. It can be settled previously, make the preset points as
sequence added to the auto cruising. You can inset preset point to the cruising, can fulfill auto cruising
between preset points. Cruising sequence can be set. You also can set the stop time of preset point, one
cruising, can be set 32 preset points.
Level, Right & Left Scan
Through keyboard and menu, users can set left position and right position, as
right.
Self-learning
This dome has the pattern scan function. The dome can record at least 180s moving track. Run the
self-learning pattern, according to the record, dome can repeat moving, one dome can set 4 routes.
Privacy masking function set
Users can set privacy masking function to cover some zone.
Alarm input & output control
When dome receive a alarm signal, run the preset action, until the alarm is finished. If have some unusual
situation, it will send another alarm signal. Dome can set 7 input alarm signals, 2 output signals.
Camera Lens Position Display
After dome self-check, the position will at 0° of level and vertical place, the level place from 0°-360° the vertical place from
0°-90°.The information can be displayed on the screen.

4 Basic Operation of Dome Camera

4.1 Camera Power On Self-Test
After connecting wires and power-on, dome camera executes self-checking program, it will appear system
information on the screen, as shown below. Camera will move horizontally to horizontal origin which was
default setting when leaving factory, then move vertically to vertical origin, lens is pulled closest and
farthest, self-check finished.
Edition number: 1.0.0
Protocol: PELCOD
Baud rate: 9600
Camera ID: 001
This information will be shown until finishing self-test for system.
Edition number: Shows information of camera software edition
Protocol: Shows type of control protocol which has been set up
Baud rate: Shows communication baud rate which has been set up, including 2400, 4800, 9600, 19200
four types of communication baud rate. Detailed setting method as per addenda.
Camera ID: Set via camera's switch SW1, detailed setting method as per addenda.
4.2 Transfer Main Menu
Open the main menu of system by pressing "menu" key on the control keyboard or by matrix via the
operation "Call No. 95 or 64 preset positions". All menu setup must first transfer main menu.
High Speed Dome Camera User's Manual
a speed scan from left to
a
- 7 -